Changes between Version 1 and Version 2 of Hand/280/HardwareSetupSettings


Ignore:
Timestamp:
May 17, 2011, 7:56:06 PM (13 years ago)
Author:
edison
Comment:

--

Legend:

Unmodified
Added
Removed
Modified

  • Hand/280/HardwareSetupSettings

    v1 v2  
    4242Attach the Power Supply Line Cord into any convenient outlet and verify that it is switched OFF.
    4343Attach the one end of the Hand Cable to the Power Supply and the other end into the Hand.  Tighten the strain-relief screws using the Phillips screwdriver provided in the toolkit.  CAUTION: Be sure you are not supplying 48 V to a 24 V hand.
    44 Check the switches on the bottom of a BH8-280 hand under the access panel.  Make sure the CAN termination is ON (SW1, !#4), SW3 is set to CAN (the side with the dot), and J35/J36 is correct for which port you are using (jumper on J36 for bottom connector).
     44Check the switches on the bottom of the hand under the access panel.  Make sure the CAN termination is ON (SW1, !#4), SW3 is set to CAN (the side with the dot), and J35/J36 is correct for which port you are using (jumper on J36 for bottom connector).
    4545
    4646