Changes between Version 3 and Version 4 of WAM/FirmwareUpdate/DetailedSafetyBoardInstructions


Ignore:
Timestamp:
Apr 5, 2012, 3:37:49 PM (8 years ago)
Author:
bz
Comment:

--

Legend:

Unmodified
Added
Removed
Modified
  • WAM/FirmwareUpdate/DetailedSafetyBoardInstructions

    v3 v4  
    5959Launch !TeraTerm/Hyperterminal (9600 baud, no parity, 8 bits, 1 stop bit, no flow control)
    6060
    61 Turn on main power to the WAM. You should get a prompt (=>). Type the following commands in sequence, each followed by <Enter>. A mis-typed command will NOT result in an error message, so type carefully! Note that this assumes you are using the stock 48 VDC power supply. Following these instructions with a different supply could damage your WAM, please contact us for custom instructions in this case.
     61Turn on main power to the WAM. You should get a prompt (=>). Type the following commands in sequence, each followed by <Enter>. A mis-typed command will NOT result in an error message, so type carefully! Note that this assumes you are using a verified 48.0 VDC power supply. Following these instructions with a different supply could damage your WAM, please contact us for custom instructions in this case.
    6262
    63631. SET X1 2000